BCP38 – also known as “Network Ingress Filtering” is concept where we filter incoming packets from end customers and allow packets ONLY from IP’s assigned to them.
Before going to BCP38, let’s first understand how packets forwarding work:
Here User 1 is connected to User 2 via a series of router R1, R2 and R3. Here R1 and R3 are ISP’s edge routers while R2 is a core router. In typical way the network is setup, entire effort is given on logic of routing table i.e for packets to reach from User 1 to User 2, we need to ensure that User 1 has default route towards R1, knows that User-2’s IP is behind R3 which is reachable via R2. So path User 1 > R1 > R2 > R3 > User 2 comes up. And same for User 2 > R3 > R2 > R1 > User 1 as return path.
Now e.g IP pool for User-1 is 192.168.1.0/24 and is using 192.168.1.2 out of it while IP pool for User-2 is 192.168.2.0/24 and is using 192.168.2.2 out of it.
End to end traces
This is pretty much how most of network setups are. Now say User-1 get’s fishy and tries spoofing packets . User-1 can add 184.108.40.206 (not allocated to him) on his loopback interface.
ip -4 addr add 220.127.116.11/32 dev lo0 and done!
Now if User 1 tries to ping user-2 with 18.104.22.168 as in source then:
ping 192.168.2.2 -I 22.214.171.124 -c 2
User 1 will not got any packets in reply since return packets will not come but forward packets will go. Let’s run
tcpdump -i eth0 -n ‘icmp’ on User-2’s machine:
Clearly user 1 is able to spoof packets and send them to User-2. While user 1 may not get back replies but this half communication in itself makes this very dangerous. This makes it prone to so many security issues like triggering a potential DoS attack with invalid IP’s or triggering DDoS attacks with DNS amplification or NTP amplification.
So what is way to deal with it? – That’s BCP38 i.e filtering on the edge. The reason it’s important to filter on edge is because this cannot be done once packets leave edge. So e.g R2 might not be familiar on which IP’s R1 has allocated to whom and hence R2 cannot prevent spoofing of IPs allocated to R1 (it can however deny all non-R1 belong IP’s though). As we go into the core networks, IP filtering becomes harder and more of a problem then solution. Hence, it is expected that networks filters their edge and large networks filter small network.
So take e.g in this case R1 can put a filter to allow packets with only 192.168.1.0/24 in source and not anything else (like 126.96.36.199)
Create an access list and permit:
access-list 1 permit 192.168.1.0 0.0.0.255 ! interface GigabitEthernet1/0 description Link to User-1 ip address 192.168.1.1 255.255.255.0 ip access-group 1 in negotiation auto
This completely prevents any spoofed packets from entering R1 from user 1. Ending this post with an interesting slide from Martin Levy from Cloudflare on extent of heavy amplification attacks done via spoofing.
Have fun and stay safe!